Gallery
We Take the CHILL Out of You!
If your heating unit is no longer working as it should, it can cause a lot of discomfort at home. If your furnace has stopped working altogether as you get ready for winter, please don’t sit at home feeling uncomfortable. Instead, you can call our furnace repair team in Waukesha for expert help.
On Time Heating & Cooling is here to help.
On Time Heating & Cooling is here to help.
Furnace Repair
If your heating system breaks just as winter arrives, it’s integral to your family’s comfort that it gets repaired as soon as possible. When you contact us about a heating repair, our furnace repair technicians in Waukesha will get out to you as soon as possible to run full diagnostics on the issue and repair your unit to ensure that it is working for years to come.
Furnace Installation
If your heating unit is no longer efficient and is draining your utility bills, our heating system installation team in Waukesha can help install a more efficient unit that aligns with your needs and your budget.
Furnace Installation
If your heating unit is no longer efficient and is draining your utility bills, our heating system installation team in Waukesha can help install a more efficient unit that aligns with your needs and your budget.
Furnace Maintenance
To ensure that your heating unit is in good working order year after year, our furnace repair team in Waukesha provides a 24-point furnace inspection that will check for any potential issues. Our furnace tune ups in Waukesha ensure that your unit is fixed so that it will continue working efficiently.
What's in our 24-point furnace inspection?
Check thermostat & make adjustments where necessary
Clean inside / outside of furnace cabinet
Test high limit / timer
Test rollout limit
Test pressure switch
Check all pressure switch / drain tubing
Remove rust & soot / clean & adjust burners
Clean & adjust ignition assembly or OHM igniter
Check microamp signal from the flame sensor
Adjust gas / air mixture for optimum efficiency
Oil motor bearings / check blower seals
Clean condensate trap on high-efficiency units
Adjust gas / pilot pressure
Inspect & adjust belts / blower wheel
Check filter & replace with consent if necessary
Check & tighten all exhaust pipe connections
Inspect & clean heat exchanger thoroughly
Ensure correct temperature rise
Check electrical wiring & tighten all electrical connections
Check CO level of exhaust
Cycle unit & make adjustments accordingly
Analyze unit’s operation & appearance
All doors are sealed & tight
Report on efficiency, condition & recommendations
Payments By:
review us on:
©2024 on time heating & cooling All rights reserved.
Designed & Developed By :
